[ Home | Contents | Search | Post | Reply | Next | Previous | Up ]
From: Jeff Fullmer
Categories:
Date: 14 Nov 2003
Time: 20:28:33
Remote Name: 68.74.140.179
I just experienced a new problem. I ground in a saw to a new profile. I was trying to shorten the face a little to cut down on the saws chattering in deep cuts. When I started to swage the saw I noticed a lot smaller swage in the two shortes teeth in the pattern. Upon investigation I found that the die was bottoming out in the gullet. The cure was of course to make the gullet deeper.